S4: Print Settings - FP Optimail30 Service Manual

Mailing system Optimail 30 – Service documentation

S4: Print Settings

S1: Imprint Offset
Steps: Print Settings
The print position is a standard 10mm from the right leading edge of the envelope. The image can be
moved a maximum of 99mm to the left.
S2: Resistance
Steps: Print Settings
The resistance of the print head can be entered. Compared to the T1000 the high resolution head has a
higher resistance. The typical range is around 2k ohms
S5: Clock
S1: Time Zone
Steps: S3: Settings
The system time is changed according to the local time zone that the meter is installed in.
S2: Summer time Changeover
Steps: S3: Settings
The daylight savings can be turned on or off
S3: Calibrate Clock
Steps: S3: Settings
The clock can be calibrated once per week up to + or -300 seconds (5 minutes). The clock can only be
readjusted after 7 days has elapsed.
S6: Scale Settings
S1: Calibrate
Steps: Scale Settings
The internal scale can be calibrated.
To calibrate the scale follow the instructions in the display. During the calibration process make sure
that the scale is not touched and also that there are no vibrations.
internal scale
S2: Zero Adjust
Steps: Scale Settings
The current weight on the scale platform is zeroed.
Zac Moody/Andrew Nagel Revision June 2005 optimail30 service mode chapter2 (dealer)
Print Offset
Resistance
Clock Time Zone
Clock Summer Time Changeover
Clock Calibrate Clock
Calibrate
Zero Adjust
FRANCOTYP-POSTALIA
10lb weight is required to calibrate the
11
Page