Removing An Interface Card - H3C S5120-HI Series Installation Manual

Figure 43 LSP5GT8P in the chassis
Figure 44 LSP5GP8P0 in the chassis

Removing an interface card

CAUTION:
Do not touch the surface-mounted components directly with your hands.
•
If no new card is to be installed, install the filler panel to prevent dust and ensure good ventilation in the
•
switch.
To remove an interface card:
1. Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded.
2. Use a Phillips screwdriver to completely loosen the captive screws at both sides of the interface
card (see callout 1 in
3. Gently pull the interface card along the guide rails until it completely comes out of the switch
chassis (see callout 2 in
Figure 45).
Figure 45).
32