H3C S5120-HI Series Installation Manual page 40

Figure 41 Removing the filler panel over an interface card slot
(1) Filler panel
3. Hold the captive screws on the front panel of the interface card, and gently push the interface card
in along the slot guide rails until the interface card is in close contact with the switch chassis (see
callout 1 in Figure
4. Tighten the captive screws with a Phillips screwdriver to secure the interface card in the slot (see
callout 2 in Figure
Figure 42 Installing an interface card
IMPORTANT:
The LSP5GP8P0 and LSP5GT8P cards can be installed only in SLOT1 of an S5120-34C-HI switch and in
SLOT1 and SLOT2 of an S5120-58C-HI switch.
The LSP5GT8P interface card adds 34.75 mm (1.37 in) to the depth of the S5120-34C-HI or
S5120-58C-HI switch (see
If you are installing an LSP5GP8P0 interface card, make sure the rack depth is 800 mm (31.50 in) or
1000 mm (39.37 in). The LSP5GP8P0 card adds 69.75 mm (2.75 in) to the chassis depth (see
in addition to the clearance required for installing transceiver modules and cables.
2
1
3
(2) Chassis rear panel
42.)
42).
Figure 43).
31
(3) Phillips screwdriver
Figure 44)