Function Code 6: Run Host Interface Wrap Test - IBM LTO Ultrium 4 Installation And User Manual

Half high tape drive

Hide thumbs

Table Of Contents

Table of Contents

is in ROM memory or flashes if the dump is in FLASH memory. If the drive

dump is stored in ROM memory (SCD Dot on solid), the dump will be lost

when you turn OFF the power or reset the drive. The SCD Dot turns off when

you obtain a dump.

2. Press the unload button once per second until

cycle past the desired code, press the unload button once per second until the

code reappears.

3. Press and hold the unload button for three or more seconds, then release it to

select the function. Then, press the unload button once per second to cycle

through the following functions:

If you cycle past the desired code, press the unload button once per second

until the code reappears.

4. Press and hold the unload button for three or more seconds, then release it to

select one of the above functions.

5. If you selected

is being performed. After the procedure is completed the drive will exit

Maintenance Mode. If you selected

indicating that a data cartridge is to be inserted.

6. Insert a scratch (blank) data cartridge that is not write protected. If you do not

insert a blank data cartridge, the tape drive will exit Maintenance Mode. The

SCD flashes the selection number while performing the function.

v If the copy operation completes successfully, the tape drive rewinds and

unloads the tape, and exits Maintenance Mode after the cartridge is removed.

v If the copy operation fails, an error code appears in the SCD. To determine

the error, locate the code in "Error codes and messages" on page 46. The tape

drive unloads the tape cartridge and exits Maintenance Mode after the

cartridge is removed.