Meaning Of Status Led And Single-Character Display (Scd) - IBM LTO Ultrium 4 Installation And User Manual

Table 3. Meaning of status LED and single-character display (SCD)
Indicator
Single- "Ready" LED
character (green)
display (red)
"1" Off
"1" Flashing Flashing
"2" Off
"3" Off
"4" Off
"5" Off
"6" Off
5
"6" or "7" Off
5
"7" Off
"8" Off
"A" Off
7
"C" Off or On
7
"C" Flashing
5
"F" Off
"H" Off
5
"J" Off
5
"P" Off
Segments Off
2
Flashing
Off Both LEDs Flashing
Together
9
On Flashing
Rapidly
10
3.0 sec On 3.0 sec On
7
Off or "C" Off
7
Off or "C" Flashing
7
Off or "C" On
7
Off or "C" Flashing
12
LTO Ultrium 4 Half High Tape Drive
"Fault" LED
(amber)
On Maximum operating temperature
exceeded
On Self test is in progress
On Input voltage failure
2
Flashing Drive firmware failure
2
Flashing Drive firmware or hardware failure
2
Flashing Unrecoverable drive failure
On Drive or media failure
On Cleaning cartridge loaded, clean
failed
On Media error
Flashing SAS interface failure
On Recoverable drive error
7
On Cleaning is required (clean bit is
set)
Off Cleaning in progress
On Incorrect firmware update tape used Replace firmware update tape.
Flashing Firmware update failed
On Incorrect (incompatible) media
On Media is write-protected (and write
operation was attempted)
Off or On Power-on self-test in progress
Firmware update is in progress
On Drive is in service mode
2
10 10
3.0 sec On After power-on self-test and drive
reset
7
Off or On No cartridge is loaded
2 7
Off or On Cartridge is loading or unloading
7
Off or On Cartridge is loaded, no activity
7
Off or On Data cartridge is loaded, activity
Status condition
1
3
4
6
8
10
Action
Reduce drive temperature.
Wait for test to complete.
Check input power
connections.
Update to latest level
firmware.
3
Clean drive and/or replace
cartridge if needed. Retry
operation. If it fails again, see
SK/ASC/ASCQ in User's
Guide for action.
Replace cleaning cartridge,
which may have expired.
Replace cartridge. Possible
expired cleaning cartridge.
Check SAS cable & connector.
Clean drive & retry operation.
Clean drive as soon as
possible.
Wait for cleaning to complete.
Retry firmware update
operation.
Insert correct media type.
Use media not
write-protected.
Wait 30-60 seconds.
Wait for update to complete.