MIXVIBES U-Mix Control Pro User Manual page 28

10 Frequently Asked Questions
2 Power the device OFF.
3 Press and hold the SHIFT and BASS_B buttons of the U-MIX CONTROL PRO.
4 Power the device ON, keep holding the SHIFT and BASS_B buttons.
5 The firmware version is given by the lighted LEDs: Version X .Y
1 X (on the deck A): 1 (PITCH MODE), 2 (SELECT), 3 (LOCATOR1), 4 (LOCATOR2), 5 (LOCATOR3), 6
(VINYL), 7 (BEND-), 8 (BEND+), 9 (SYNC)
2 Y (on the deck B): 1 (PITCH MODE), 2 (SELECT), 3 (LOCATOR1), 4 (LOCATOR2), 5 (LOCATOR3), 6
(VINYL), 7 (BEND-), 8 (BEND+), 9 (SYNC)
6 Press SHIFT to go back to normal Mode.
How do I upgrade my controller's firmware?
1 Make sure your controller is connected via USB to the computer.
2 Power the device OFF.
3 Press and hold the SHIFT and BROWSE buttons of the U-MIX CONTROL PRO.
4 Power the device ON, keep holding the SHIFT and BROWSE buttons.
5 Both "SOURCE(AB)" buttons should light up (SHIFT and BROWSE buttons shouldn't be pressed anymore).
6 A new drive named "midiUpgDisk" should be found in your system.
7 Drag and drop the firmware file ("U-MIX_PRO_*V*.bin") into the "midiUpgDisk" drive.
8 The Kill-LEDs will start to flash while upgrading: BASS(AB): Update Data (30%), MID(AB): Update Data
(60%), TREB(AB): Update Data (90%), LOAD(AB): Update Success (if LOAD(AB) Turn Off means Updating
Error).
9 After the firmware is updated, the LEDs will turn off.
Can I use U-MIX CONTROL PRO with DJ software other than CROSS
DJ?
Yes, your U-MIX CONTROL PRO is a standard MIDI controller that sends MIDI commands. U-MIX CONTROL PRO can
be used with any software that accepts MIDI commands.
How can I record the mixes that I create with the U-CONTROL MIX
PRO?
You can record your mix by choosing whether you want to save the channel A, B or Master and then by clicking on
the REC button present in the upper part of the integrated mixer of CROSS DJ. You can customize the recording
settings in [File > Preferences > Recording].
C
M
Y
CM
MY
CY
CMY
K
28 /
30
vibe-watermark-bright.pdf