Fleck 5600 SXT Programming

Hide thumbs Also See for 5600 SXT:

www.h2ofilters.ca

FLECK 5600 SXT WATER

SOFTENER PROGRAMMING

TO ENTER INTO MASTER PROGRAMMING: Press the arrow up button and set the time to 12:01

P.M., then press the extra cycle button once. Now press the up and down buttons together for

approximately 8 seconds until the display changes to the programming mode.

The display should now be:

Press the Extra Cycle button to advance to the next step.

Next display should be:

Press the Extra Cycle button to advance to the next step.

Next display should be:

Press the Extra Cycle button to advance to the next step.

Next display should be:

Press the Extra Cycle button to advance to the next step.

Table of Contents

Need help?

Do you have a question about the 5600 SXT and is the answer not in the manual?

Page 1 FLECK 5600 SXT WATER SOFTENER PROGRAMMING TO ENTER INTO MASTER PROGRAMMING: Press the arrow up button and set the time to 12:01 P.M., then press the extra cycle button once. Now press the up and down buttons together for approximately 8 seconds until the display changes to the programming mode.
Page 2 www.h2ofilters.ca Next display should be: You may need to use the arrows to adjust this setting. For a 1.5 cubic foot (45,000 grain) softener set this to 35.0, for a 1.0 cubic foot (30,000 grain) softener, set it to 27.0. Press the Extra Cycle button to advance to the next step.
Page 3 www.h2ofilters.ca Next display should be: Press the Extra Cycle button to advance to the next step. Next display should be: You may need to use the arrows to adjust this setting. For a 1.5 cubic foot (45,000 grain) softener set this to 9 and for a 1.0 cubic foot (30,000 grain) softener, set it to 6.