Advertisement
WARNINGS
TABLE ASSEMBLY INSTRUCTIONS
Parts Included:
1 - Wrench
STEP 1
Place the table top upside down on the floor.
STEP 2
Place the shelf upside down on top of the table skirt.
(Fig. 1) Each leg has a number by the top bolt that
corresponds with a number on the inside corners of
the table's base.
STEP 3
Place the top leg bolt through the metal
corner bracket in one corner of the table skirt. (Fig.
1 inset) For flex top models, it may be necessary to
raise the foot section to install the leg.
Figure 1
1
8 - Nylock
8 - Washers
Nuts
Shelf Assembly
Table Top &
Skirt Assembly
4 - Main Legs
w/extensions
STEP 4
Lift the same corner of the table shelf and place the
bottom leg bolt through the metal corner brackets on
the shelf.
STEP 5
Place a flat washer and nut on each bolt. Do not
tighten. (If cabinet is included, please go to step 1
below.)
STEP 6
Repeat steps 3-5 on remaining corners, installing the
remaining three leg assemblies to the skirt and shelf.
STEP 7
Using the included wrench, or a 1 /2" wrench, tighten
all eight nuts securely. When tight, assembled unit
should look like figure 2.
Leg Assembly
1 - Table Top
1 - Shelf
Nylock Nut &
Washer (4 ea.)
Figure 2
(As viewed from underside)
Advertisement
