Siemens simatic hmi op7 Equipment Manual page 157

Mes- Cause
sage
685 Configuration error. Two tags that supply infor-
mation about the faulty function (Tag 1) and the
faulty parameter (Tag 2) are transferred together
with this message.
Variable 1:
535 Conversion, Linear 1
536 Conversion, Linear 2
537 Increment, variable
539 Increment current
545 Convert value
Variable 2:
This specifies the parameter of the function in
which an error has arisen (e.g. Tag 2 = 3: parame-
ter 3 of the Tag 1 function is faulty).
686 Too many variables.
701 Internal error
Incorrect assignment of "head –> res" when re-
ceiving variable.
702 Job can not be executed.
703 Flash memory full.
704 Incorrect CPU specified under "PLC –> Parame-
ters".
705 An acknowledged message can not be entered in
the buffer because the corresponding message or
a message in the same acknowledgement group is
missing.
706 Recipe request will not be processed as another
request is already active.
707 Internal error
S7 message task error.
708 Internal error
Incorrect mailbox type
709 Internal error
Invalid mailbox type.
710 Internal error
Incorrect mode.
711 Internal error
Display status invalid.
712 No submenu configured.
713 Internal error
No special operator object configured.
Equipment Manual OP7, OP17
Release 04/99
Remedy:
If you are dealing with a configura-
tion error: delete the function and re-
configure.
Or if the OP tries to determine the
value of a tag while no PLC is con-
nected: connect a PLC.
Change interface or configure area
pointer.
Restrict the configuration.
Change configuration and retransfer.
B-15