Table of Contents
Advertisement
Mes-
Cause
sage
338
OP can not establish a connection with the prin-
ter.
339
Startup completed.
340
Status processing in progress on PU/PC. The OP
can not be used while this is going on.
341
Internal error
With non-Siemens connections: data block error
342
Network node has illegal address.
353
The minimum value is greater than the maximum
value for variable scales.
359
The CPU is in STOP mode.
366
– The mode you require is already active.
– The CPU key-operated switch is not set to
RUN-P.
– The command is not supported by the CPU.
367
Set PLC parameters are incorrect.
368
Communication error S7 module; error class and
error number will be read out.
369
The command cannot be executed in the S7 mode
selected.
392
– No alarm messages are queued on the NC.
– Acknowledgement is not possible in the NC
mode set.
393
The password is incorrect or you cannot enter a
password in the NC mode set.
394
Acknowledgement is not possible on the NC set.
395
– No part programs have been configured.
– The PLC specified (FM or NC) is not ready.
396
– The part program specified does not exist.
– The PLC specified (FM or NC) is not ready; in
the case of FM: no user data area has been created
on the PLC.
Equipment Manual OP7, OP17
Release 04/99
Remedy:
1. Printer is not switched on,
2. Printer is not ready,
3. Connecting lead between printer
<––> OP is not connected or defec-
tive,
4. No interface module inserted.
Communication with PLC has been
resumed.
Max. addresses:
S7-MPI:
32
PROFIBUS-DP:
128
Minimum and maximum values are
being confused by OP. To prevent
this, enter correct minimum and ma-
ximum values.
System error message issued if S7
messages are not available.
B-7
Hide quick links:
Advertisement
Table of Contents
