Table of Contents
Advertisement
RX-64
2-4. Connection of Main Controller
Main Controller
Connection with PC
Connection with UART To control RX-64 with a personally made Main Controller, the signal of Main Controller
RX-64 uses the Multi-Drop Link method which connects several RX-64s to a Node by
using Half Duplex UART. Thus, a Main Controller to run RX-64 must support RS485
UART. You can also design and use Main Controller by yourself.
(Refer to the website
www.robotis.com
If you want to control RX-64 with PC, you may control it via the Dynamixel-only controller
or using the USB2Dynmixel. For further information, refer to the Dynamixel-only
controller manual or the USB2Dynmixel manual.
Serial
cable
UART should be converted into RS485 type signal. The following is a recommended
circuit diagram.
)
Dynamixel-only
Controller
Power line
USB PORT
USB2Dynamixel
Power line
12
Advertisement
Table of Contents
