LG 26TS30MF Installation Manual page 54

D. Appendix 2 : Troubleshooting
Problem
Did Calibration fail?
Is there any abnormal working at
SSC or monitor?
(e.g : R/G/B gains are over 192 after
calibration or SSC is hang-up or
terminated abnormally and so on.)
Is the white color different between
video wall screens after calibration?
There is color mismatching after
calibration.
Did you use Duplication function?
Calibration pop up message
Set to the maximum luminance
Set to the minimum luminance
Fail to adjust color temperature
Please manually adjust Gain Value
Fail to change backlight
Fail to change the mode
Fail to set RGB Gain/offset
Fail to find sensor error
Refer to the Version Matching chart.
And If needed update both SOC(Flash) and Micom to the
latest version.
Check "Create Gamma Table" and calibrate again.
If the result is same, please adjust manually.
Note) If you set color temperature as over 11000,
"Create Gamma Table" should be checked for stable
working.
More than 2 screens may have individual color and
brightness uniformity, this lack of uniformity could make
them to look different.
So proceed the manual adjustment white balance more
correctly.
There could be problem when you use Duplication function
because of the uniformity of panel.
If you used Duplication function to reduce processing time,
we'd like to recommend doing calibration without "Create
Gamma Table".
Reduce the target luminance level to a proper range.
Set ISM mode to normal.
Increase the target luminance level to a proper range.
Adjust manually.
Set both Energy saving and Easy Brightness of Picture
menu to off.
Check the control connection such as RJ45, RS232.
Adjust manually.
Check the control connection such as RJ45, RS232.
Make sure your sensor is connected well to the unit being
calibrated.
Resolution
Resolution
54