Important Safety Requirements - Honeywell MP Nova Mark II User Manual

Chapter 1 — Safety Information

Important Safety Requirements

2
Honeywell disclaims all responsibility regarding the CE directive if the printer is
used, altered or installed in any way other than described in this manual.
This symbol is used to indicate circumstances that may be dangerous to the user
or that cause damage to the equipment.
• Never use sharp or pointed tools when cleaning or replacing the printhead.
• Remember to handle the printhead with care.
• Don't use any sharp objects to remove labels from the print roller.
• The MP Nova Mark II printers have double fuses. The fuses are rated at 250
V, 4.0 A, AT-type. Fuses must be UL-approved.
• The circuit board contains a battery. Used batteries should be disposed of in
accordance with the manufacturer's instructions.
• Please read all instructions before using the printer for the first time.
• The printer should be connected to the power supply indicated on the voltage
plate. If you are unsure of the type of power supply available, please contact
Honeywell service personnel.
• The printer is equipped with a plug suitable for grounded sockets. This is a
safety measure. If the plug does not fit the power socket, a qualified
electrician must replace it.
• We do not recommend the use of extension cables.
• The power cable must not be subjected to pressure. Ensure that the printer is
not placed anywhere where a person could stand on the power cable.
• Check that the power switch is off (in the '0' position) before connecting the
power cable.
• Do not use liquids or aerosols when cleaning this printer. Always use
Honeywell's special cleaning cloths.
• Do not attempt to open the electronic unit or other sealed parts! The user
cannot service these parts.
• Do not use cables that exceed 5 m (16.5 in.) in length for RS-232
communication. Signals may be corrupted or lost as a result. This is
particularly important in environments where there are high levels of electrical
interference.
• Disconnect the power to the printer and call in qualified personnel under the
following conditions:
• The power cable or plug is damaged or worn.
• Liquid has been spilled on the printer.
MP Nova Mark II User Guide