Table of Contents
Advertisement
In VFO mode, press "F+*" keys to start scanning.
The scan will begin at the current frequency and
continue up the band. To reverse the scan direction,
press the "
the "
▲
MR/CH scan: Scan only programmed memory
channels in this mode. From MR/CH mode, press
"F+*" keys to start scanning, scanning begins on the
current channel and scans up to higher channel
numbers. To reverse the scan direction, press the
"
" key. Scan up the band again by using the "
▼
key Press any other key to stop scanning.
Note:
a)
Each memory channel can be set to be blocked from
scan through Scan Add. Press "F+0" keys to enable or
disable Scan Add. If Scan Add is disabled on a channel,
that channel will be skipped during MR/CH scans. If a
channel's Scan Add is disabled,
on the transceiver's display.
b)
MR/CH Scan is only available if two or more channels
are programmed with Scan Add enabled.
c)
Scan is only effective if the squelch is closed.
Tail Elimination (Tail): Menu 24
The Tail elimination function eliminates the burst of
background noise encountered at the end of a
transmission. Set Menu 24 to ON if you would like to
enable this feature, or OFF to disable it. The default is
ON.
" key. Scan up the band again by using
▼
" key. Press any other key to stop scanning.
31
will be indicated
"
▲
Advertisement
Table of Contents
