Offset Frequency (Rpt Set): Menu 22 - Leixen LX928 User Manual

Offset Frequency (RPT SET): Menu 22

You can set a channel to use different receive and
transmit frequencies. This is most useful for operating
through a repeater, which receives on one frequency and
then retransmits on another frequency from a higher
antenna. This effectively provides systems using the
repeater with greater communication range than they
would achieve alone.
Setting these separate frequencies is accomplished by
setting Menu 22, and select "RPT+/RPT-". First, you will
need to set the offset amount, which is the difference
between the receive and transmit frequencies. The
LX-928 can accept offset values from 0.000 to 69.995
MHz.
In VFO Mode, select Menu 22. Enter the offset value
using the numerical keys on the keypad, or by using the
keys.
▲ or ▼
Select the SING/RPT+/RPT- via press "F+9". Using the
" or " keys, select "RPT+" (positive offset, the
▲" ▼"
transmit frequency is higher than the receive frequency),
"RPT-" (the transmit frequency is lower than the receive
frequency), or "SING" (no offset, only a single frequency
is used).
For example: In VFO mode, enter a frequency such as
450MHz, and set the offset to 5MHz. If RPT Type is
"RPT+", then the receive frequency is 450MHz, and the
transmit frequency is 455MHz; if RPT Type is "RPT-",
then the receive frequency is 450MHz, and the transmit
29