Table of Contents
Advertisement
microphone and speak normally. Release the PTT key to
stop transmitting.
Please use Low Power whenever possible. If the
distance between you and the other station is short,
low power (2 watts) should be adequate. Using low
power when possible will not only use less power
from your battery or power supply, but your
transmitter will also produce less heat, increasing the
life of your final amplifier.
For best voice quality, hold the microphone about 2
IN (5 cm) away from your mouth and speak
normally.
A red LED indicates that the transmitter is active.
Programmable key settings
The P1, P2 and Menu keys are user programmable. While
the short press of the Menu key can only be changed in
the programming software, the P1, P2 keys can be
programmed using Menus 14-17.
Each of these keys has two programmable functions,
accessed by a short press (press and release) or a long
press (Press and hold for 1.5 seconds). Each of these
functions is set in one of the programmable key menus.
Note: If you would like to change the hold time for Long
Press, you may do so using the programming software.
You may set any of the programmable keys to perform
the following functions:
14
Advertisement
Table of Contents
