Table of Contents
Advertisement
16 separate codes. These codes represent digits 0-9, plus
*, #, A, B, C, and D. The LX-928 can generate and
decode DTMF sequences in order to control other
equipment, remotely control or inhibit other LX-928
transceivers, or page individual radio users or groups of
users. Each of the 199 channels can be individually
programmed for DTMF signaling to be enabled or
disabled. Note that if DTMF is disabled on a channel, it
can neither be transmitted nor decoded.
Enable Or Disable DTMF Signaling
1, In VFO / MR mode, select a frequency or memory
channel to modify DTMF signaling. Alternatively, you
can enable DTMF signaling in the programming
software.
Note:
a), If the transceiver is in CH mode, you can not enable or disable
DTMF signaling from the transceiver's front panel. In CH mode,
this setting can only be modified from the programming software.
b), In MR mode, each memory channel can be independently set to
have DTMF signaling enabled or disabled.
2, Access menu 06 and press the "MENU" key to open
the menu, select "ON" or "OFF" to enable or disable
DTMF signaling. The default setting is ON. Once you
have made your selection, press the "MENU" key to
confirm and exit.
Individual call/ group call
Individual call: Using the LX-928 programming
20
Advertisement
Table of Contents
