Filter Insert; Putting Into Operation; Interrupting Work - WAGNER G 15 Operating Instructions Manual

7. Filter insert

Pull trigger guard (1) firmly forward. Screw off
handle (4). Insert a suitable filter insert (2) with the
longer taper into the gun housing, The compres-
sion spring (3) is housed in the handle where it is
safe against loss. Screw on handle.
Filter Application
insert
Order no.
0034 383* Stains, glosses,
0097 022** clear coats,
synthetic resin
paints
0043 235* Undercoats, base
0097 023** coats, fillers,
marking paints,
primers
0034 377* Emulsions,
0097 024** latex paints,
acrylic paints
0089 323* Filling paints,
0097 025** large-surface
coatings
10
Filter Mesh no. Mesh
type size
mm
super 180 0,084
fine
fine 100 0,140
me- 50 0,315
dium
coarse 30 0,560
g

8. Putting into operation

Put airless high-pressure pump into operation
according to manufacturers instructions. Set
required operating pressure. Unlock the safety
catch on the airless spray gun and pull the trigger.
To stop spraying, release the trigger.

9. Interrupting work

Important
The airless spray gun must always be made "safe"
with the safety catch if you temporarily stop work.
If the spray equipment is left unsupervised over
longer periods, or if work needs to be done on the
spray equipment, then the operating pressure
must be relieved.
10. Cleaning
Color of
filter
After stopping work for the day, relieve the
operating pressure. Unscrew spray jet touch guard
along with the tip. Flush airless high-pressure
red
pump, medium hose and airless spray gun with a
suitable cleaning agent at low operating pressure.
Clean tip thoroughly with a suitable cleaning
yellow
agent, so that no coating medium residue remains.
Clean the outside of the airless spray gun
thoroughly. Lubricate safety catch and trigger with
silicon-free oil from time to time. To clean the filter
white
insert, please refer to Maintenance.
green
*1, ** 10