Transporting And Storage; Line Trimmer Safety - Yardworks 060-2343-8 Instruction Manual

4
model numbers 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218
Use a container approved for fuel.
Do not smoke or allow smoking near fuel
or the unit.
Avoid spilling fuel or oil. Wipe up all fuel
spills.
Move at least 10 feet (3 meters) away from
the fueling site before starting the engine.
Stop the engine and allow it to cool before
removing the fuel cap.
Always store gasoline in a container

TRANSPORTING AND STORAGE

Allow the engine to cool; secure the unit
before storing or transporting in a vehicle.
Empty the fuel tank before storing or
transporting the unit. Use up fuel left in
the carburetor by starting the engine and
letting it run until it stops.
Store the unit and fuel in an area where
fuel vapors cannot reach sparks or open
or switches, furnaces, etc.
Store the unit so that the line limiter blade
cannot accidentally cause injury. The unit
can be hung by the shaft.
Store the unit out of reach of children.
SAFETY NOTICE: Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause blood vessel
and joints of people prone to circulation
disorders or abnormal swellings. Prolonged
use in cold weather has been linked to blood
vessel damage in otherwise healthy people.
If symptoms occur such as numbness,
pain, loss of strength, change in skin color
hands, or joints, discontinue the use of
this tool and seek medical attention. An
anti-vibration system does not guarantee
the avoidance of these problems. Users
who operate power tools on a continual and
regular basis must monitor closely their
physical condition and the condition of this
tool.
SPECIAL NOTICE: This unit is equipped
spark arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require
by law that many internal combustion
engines be equipped with a spark arresting
screen. If you operate in a locale where
such regulations exist, you are legally
responsible for maintaining the operating
condition of these parts. Failure to do so is a
violation of the law. For normal homeowner
will not require any service. After 50 hours
be serviced or replaced by your authorized
service dealer.

LINE TRIMMER SAFETY

a WARNING: Inspect the area before
Use only for trimming, scalping, mowing and
sweeping. Do not use for edging, pruning or
hedge trimming.
STRAIGHT SHAFT TRIMMER — Cut from
your left to your right. Cutting on the right
side of the shield will throw debris away
from the operator.
CURVED SHAFT TRIMMER — Cut from
your right to your left. Cutting on the left side
of the shield will throw debris away from the
operator.