Before Starting The Engine; Fueling The Engine; How To Stop Your Unit; How To Start Your Unit - Yardworks 060-2343-8 Instruction Manual

8
model numbers 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218

BEFORE STARTING THE ENGINE

a WARNING: Be sure to read the fuel
information in the safety rules before
the safety rules, do not attempt to fuel

FUELING THE ENGINE

a WARNING: Remove the fuel cap
IMPORTANT: This equipment is designed
to operate on unleaded gasoline with a
minimum 87 octane (R+M/2 method), with
ethanol blended up to 10% maximum by
volume (E 10). Before operation, gasoline
must be mixed with a good quality synthetic
2 cycle air cooled engine oil designed to be
mixed at a ratio of 50:1. Mix gasoline and
oil at a ratio of 50:1. A 50:1 ratio is obtained
gallon of unleaded gasoline. DO NOT USE
automotive oil or marine oil. These oils
will cause engine damage. When mixing
fuel, follow the instructions printed on the
container. Once the oil is added to the
gasoline, shake the container momentarily
to assure that the fuel is thoroughly mixed.
Always read and follow the safety rules
relating to fuel before fueling your unit.
Purchase fuel in quantities that can be used
within 30 days to assure fuel freshness.
CAUTION: Never use straight gasoline
engine damage and void the limited
as ethanol blends above 10% by volume
(E 15, E 85) or any methanol-blended
engine performance and durability

HOW TO STOP YOUR UNIT

Release the throttle trigger.
Push and release the engine ON/STOP
switch. The switch will automatically return
to the ON position. Wait 5 seconds before
attempting to restart the unit to allow the
switch to reset.

HOW TO START YOUR UNIT

a WARNING: Avoid any contact with

STARTING A COLD ENGINE

NOTE: DO NOT squeeze the throttle trigger
until the engine has started and runs.
1. Slowly press the primer
bulb 6 times.
2. Move the start lever to the
START position.
3. Pull the starter rope
handle sharply until the
engine starts and runs.
4. Allow the unit to run for
15 seconds, then fully
squeeze the throttle
trigger to disengage the
starting system.
It is recommended that the
engine not be operated for
longer than 1 minute at full
throttle.