Page 1
Cordless Telescopic Grass Trimmer & Edger model number 060-2341-2 | contact us: 1.866.523.5218 Conforms to UL STD 82 Certified to CAN/CSA STD. C22.2 No.147-M90 IMPORTANT: Instruction Read and follow all safety rules and operating Manual instructions before using this product.
060-2341-2 | contact us: 1.866.523.5218 FOR ALL APPLIANCES stored indoors in dry places out of reach of children. • Avoid dangerous environments - do not • Maintain appliance with care. Follow use appliances in damp or wet locations.
Page 4
060-2341-2 | contact us: 1.866.523.5218 • Do not dispose of the battery in a fire. The • Never put batteries in one’s mouth. If swallowed, contact local poison control cell may explode. Check with local codes for possible special disposal instructions.
Page 5
060-2341-2 | contact us: 1.866.523.5218 • Disconnect the battery pack from the These limits are designed to provide appliance before making any adjustments, reasonable protection against harmful changing accessories, or storing appliance. interference in a residential installation. This...
060-2341-2 | contact us: 1.866.523.5218 1. ASSEMBLY OF THE SAFETY GUARD (SEE FIG. A1, A2, A3) Remove the screw (a) from the guard (SEE FIG. A1). Attach the safety guard to the trimmer head. Align the guard so it slides into the slots located on the trimmer head (SEE FIG. A2).
060-2341-2 | contact us: 1.866.523.5218 1. BEFORE USING YOUR CORDLESS GRASS TRIMMER The battery pack included is shipped UNCHARGED. You must charge before first use. The battery charger supplied was designed to only charge the Li-on battery also supplied. Do not use another battery charger.
Page 11
060-2341-2 | contact us: 1.866.523.5218 4. SAFETY ON/OFF SWITCH (SEE FIG. D) The on/off switch is locked off to prevent accidental starting. Depress the lock off button (a) then depress the on/off switch (b) and release lock off button. Your trimmer is now on. To switch off, just release the on/off switch.
Page 12
060-2341-2 | contact us: 1.866.523.5218 6. ADJUSTING THE HEIGHT (SEE FIG. G) Rotate the Height adjustment locking mechanism to loose it. Adjust the length of the Aluminum tube to be more comfortable for you, then rotate the Height adjustment locking mechanism to the opposite direction to ensure it is fixed firmly.
Page 13
060-2341-2 | contact us: 1.866.523.5218 ADJUSTING FLOWER GUARD (SEE FIG. J) Lift the flower guard up when edging and put it down before trimming, as shown in Figure I. Before trimming or edging make sure the flower guard is locked firmly in position.
060-2341-2 | contact us: 1.866.523.5218 1. TRIMMING Do not cut wet grass because it tends to stick to the trimmer head and guard, prevents proper discharge of grass clippings, and could cause you to slip and fall. Regularly remove clippings and dirt around the trimmer head with a switched off trimmer.
Page 15
060-2341-2 | contact us: 1.866.523.5218 2. EDGING(SEE FIG. K1-K3) Change the tool from trimming to edging mode by adjusting the cutting angle to be in the lowest horizontal setting as shown in Fig K1. Then push the Handle rotation locking mechanism downward and rotate the main handle 90°...
Page 16
060-2341-2 | contact us: 1.866.523.5218 4. TO MANUALLY FEED THE LINE (SEE FIG. L) If required, line can be fed out manually. Before manually feeding, remove the battery first. To operate, press and release manual line feed button (a), while gently pulling out the lines until the lines reach the line cutter.
060-2341-2 | contact us: 1.866.523.5218 7. TO FIT SPOOL AND LINE COMPLETE (SEE FIG. N) Remove old spool. Place new spool into cap with cut out areas of the spool in line with eyelets. Release line from cleat and feed line through eyelet.
Page 18
060-2341-2 | contact us: 1.866.523.5218 8. TO FIT NYLON LINE ONLY: Wind spool with new line (SEE FIG. O1,O2, O3) IMPORTANT! Your trimmer is designed to use only line with a maximum diameter of 1.65 mm. 1. Remove the empty spool from the tool as described in “TO REPLACE CUTTING LINE”...
060-2341-2 | contact us: 1.866.523.5218 Always remove the battery pack from your trimmer after use. Store in a dry place where the trimmer and battery can be protected from damage. Remove the battery before carrying out any adjustment, servicing or maintenance.
060-2341-2 | contact us: 1.866.523.5218 The following chart lists problem symptoms, possible causes and corrective action, if your electric grass trimmer does not operate properly. If these do not identify and correct the problem, contact your helpline. Problems...
060-2341-2 | contact us: 1.866.523.5218 Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the product effectively and safely.
060-2341-2 | contact us: 1.866.523.5218 TWO-YEAR LIMITED WARRANTY HOW TO OBTAIN SERVICE Warranty service is available by calling For Two (2) Years from the date of the toll-free helpline, at 1-866-523-5218. purchase within Canada, YARDWORKS The factory will not accept the return...
Page 24
Made in China. Imported by Yardworks Canada Toronto, Canada M4S 2B8...