Stihl SG 31 Instruction Manual page 6

English
Plant protection chemicals may be used
only by persons trained in their handling
and the appropriate first-aid measures.
Keep instructions or label of the plant
protection chemical available at all times
in order to inform the doctor about the
chemical concerned in an emergency. In
an emergency, follow the chemical
manufacturer's instructions provided or
on the label. Observe manufacturer's
safety data sheets.
Mixing plant protection chemicals and
filling tank
Use plant protection chemicals only as
specified by the manufacturer.
Before filling the tank with
–
chemicals, carry out a test with fresh
water and check all parts of the
sprayer for leaks.
Never apply undiluted liquid
–
concentrates of plant protection
products.
Mix the plant protection chemical
–
and fill the tank outdoors only or in
well-ventilated locations.
Only mix sufficient solution for the
–
job in hand so that nothing is left
over.
Do not mix different plant protection
–
products unless such a mixture is
approved by the manufacturer.
Mix different chemicals only in
–
accordance with the manufacturer's
instructions – incorrect mixtures
may produce toxic fumes or
explosive solutions.
Stand the sprayer on a level surface
–
– do not fill the tank above the
maximum mark.
4
When filling from central water
–
supply, do not immerse the end of
the hose in the solution – sudden
low pressure in the system may
cause the solution to be sucked
back into the water supply.
To reduce the risk of injury, do not
–
fill the sprayer while carrying it.
Close the tank tightly after filling.
–
Application
Work only in the open or in very well
–
ventilated locations, e.g. open
greenhouses.
Do not eat, drink or smoke while
–
working with plant control
chemicals.
Never blow through nozzles or other
–
components by mouth.
Do not spray in windy conditions.
–
Too high or too low a spray pressure or
unfavorable weather conditions can
result in the wrong solution
concentration. Overdosing may damage
plants and the environment. Under-
dosing may result in unsuccessful plant
treatment.
To reduce the risk of damage to plants
and the environment, do not operate the
sprayer:
if pressure is too high or too low
–
in windy conditions
–
at temperatures above 30 °C in the
–
shade
in direct sunlight
–
In order to reduce the risk of accidents
and damage to the sprayer, never
operate the sprayer with:
flammable liquids
–
viscous or sticky liquids
–
caustic or corrosive chemicals
–
liquids hotter than 30 °C
–
Storage
During work breaks, do not leave
–
the sprayer in the hot sun or near
any heat source.
Do not store plant protection
–
chemical in the sprayer for longer
than one day.
Store and transport plant protection
–
products only in approved
containers.
Never store the plant protection
–
products in containers intended for
foods, drinks or animal feed.
Do not store plant protection
–
products with foods, drinks or
animal feed.
Keep plant protection products out
–
of the reach of children and animals.
Store the sprayer empty and clean.
–
It must not be under pressure.
Store plant protection products and
–
power tool in a place secured
against unauthorized use.
Store the unit in a dry place
–
protected from frost.
SG 31