Marantz CDR630 Owner's Manual page 7

DIG AUTO TRACK REPEAT 1 TOTAL
ANALOG
PROG
RECORDABLE L
-50 -40 -30 -20
R
CD REWRITABLE
To set the desired recording level, start playing the analog
source and adjust the recording level using the record level
knob (16) so that all of the blue but none of the red segments
light up on the recording and playing level indicator on the dis-
play during the loudest fragments.
DIG AUTO TRACK REPEAT 1 TOTAL
ANALOG
PROG
RECORDABLE L
-50 -40 -30 -20
R
CD REWRITABLE
If you want a period of silence at the beginning of a new num-
ber, press PAUSE (14). A three-second pause (silence) will be
recorded.
2 Press PLAY (13) to start recording, and immediately start the
analog source.
The relevant track number and the recording time used will be
displayed. Press the Display button (18) to view the amount of
total recording time remaining.
3 Press the STOP button (15) to stop in the recording modes.
Note:
- In the automatic mode, recording will stop after a twenty
second silence (< -50dB) on the original.
You can also use the PAUSE button (14) instead of the STOP
(15) button if you want to stop and re-enter the Record-Pause
mode.
After recording, the temporary table of contents of the disc will
be automatically up-dated. During this process, the display will
indicate UPDATE .
DIG AUTO TRACK REPEAT 1 TOTAL
ANALOG
PROG
RECORDABLE L
-50 -40 -30 -20
R
CD REWRITABLE
Attention!
If you want to play the disc in another, regular CD-
player, the disc must be finalized. See 'Finalizing
discs' p. 11.
Manual recording from a digital
source
Preparations for recording
In order (depending on the connection used) to record from a CD,
DAT or MD
1 Press the INPUT button (19) a number of times until CXL
SRC , CXL 44 , OPT SRC or OPT 44 appears on the
display.
REM TRACK TIME CD SYNC
RECORD
FINALIZE
ERASE
-10 -6 -3 0 OVER
PAUSE
REM TRACK TIME CD SYNC
RECORD
FINALIZE
ERASE
-10 -6 -3 0 OVER
PAUSE
REM TRACK TIME
CD SYNC
RECORD
FINALIZE
ERASE
-10 -6 -3 0
OVER
PAUSE
DIG AUTO TRACK REPEAT 1 TOTAL
ANALOG
PROG
RECORDABLE L
-50 -40 -30 -20
CD R
REWRITABLE
CXL SRC and OPT SRC are displayed in SRC-on mode (Sample
Rate Conversion).
CXL 44 and OPT 44 are displayed in SRC-off mode.
If you want a full (1 to 1) copy (CXL 44 or OPT 44), a stable source
with sample frequency of 44.1 kHz +/- 100 ppm must be used.
2 By pressing AUTO/MANUAL (17), you can select manual or
automatic track marking. If "automatic" is selected, 'AUTO
TRACK' will appear on the display.
AUTO TRACK REPEAT 1 TOTAL
DIG
ANALOG
PROG
RECORDABLE L
-50 -40 -30 -20
R
CD REWRITABLE
In Auto mode, track numbers are automatically detected from
the digital source material. In this mode, you cannot insert track
numbers manually.
In the manual mode, you can add track numbers at any point
by pressing on REC (7) or TRACK INCR (37) (on the remote
control). The minimum track length is four seconds. Increments
cannot be inserted after recording.
Note:
- If you try to make a full (1 to 1) copy [OPT 44, CXL 44] of a digi-
tal source that does exceed the 44.1 kHz +/- 100 ppm range,
recording will most likely not start. In some rare cases, mutes
may occur and recording may stop. Use a better source or use
OPT SRC or CXL SRC to avoid these problems.
To start recording
1 Press the REC (7) button to enter the Record-Pause mode. .
The display indicator 'RECORD' will start flashing.
DIG AUTO TRACK REPEAT 1 TOTAL
ANALOG
PROG
RECORDABLE L
-50 -40 -30 -20
R
CD REWRITABLE
If the digital connection is incorrect, the display indicator 'DIG'
will flash.
REPEAT 1
DIG AUTO TRACK TOTAL
ANALOG
PROG
RECORDABLE L
-50 -40 -30 -20
R
CD REWRITABLE
If the digital source exceeds the 44.1 kHz +/- 100 ppm range
and CXL44 or OPT44 is selected, the display indicator DIG will
flash. When the source gets better (for example by adjusting a
bad cable connection) the label stops blinking.
If you want a pause at the beginning of a new track, press the
PAUSE button (14). A three-second pause (silence) will then be
recorded.
REM TRACK TIME CD SYNC
RECORD
FINALIZE
ERASE
-10 -6 -3 0
OVER
PAUSE
REM TRACK TIME
CD SYNC
RECORD
FINALIZE
ERASE
-10 -6 -3 0
OVER
PAUSE
REM TRACK TIME CD SYNC
RECORD
FINALIZE
ERASE
-10 -6 -3 0 OVER
PAUSE
REM TRACK TIME CD SYNC
RECORD
FINALIZE
ERASE
-10 -6 -3 0
OVER
PAUSE
9