After Finishing Work; Transporting The Chain Saw And Battery; Transporting The Chain Saw; Transporting The Battery - Stihl MSA 120 C Instruction Manual

English
► Shout a warning.
► With arms outstretched, cut through the holding strap from
outside at a downward angle.
The tree falls.

13 After Finishing Work

13.1 After Finishing Work
► Switch off the chain saw, engage the chain brake and
remove the battery.
► If the saw is wet: Allow the saw to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the saw.
► Clean the bar and chain.
► Loosen the wingnut.
► Rotate the adjusting wheel two full turns
counterclockwise.
The chain is now slack.
► Tighten down the wingnut.
► Fit the scabbard so that it completely covers the guide bar.
► Clean the battery.
76
14 Transporting the Chain Saw and
Battery

14.1 Transporting the Chain Saw

► Switch off the chain saw, engage the chain brake and
remove the battery.
► Fit the scabbard so that it completely covers the guide bar.
► Carry the saw by the handlebar with the guide bar pointing
to the rear.
► Transporting the saw in a vehicle: Secure the saw to
prevent it turning over or shifting.

14.2 Transporting the Battery

► Switch off the chain saw, engage the chain brake and
remove the battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the transport
of dangerous goods. The battery is classified as UN 3480
(lithium-ion batteries) and has been tested in accordance
with UN Manual of Tests and Criteria, Part III, sub-section
38.3.
For transport regulations see www.stihl.com/safety-data-
sheets
15 Storing the Chain Saw, Battery and
Charger

15.1 Storing the Chain Saw

► Switch off the chain saw, engage the chain brake and
remove the battery.
► Fit the scabbard so that it completely covers the guide bar.
► Observe the following points when storing the saw:
13 After Finishing Work
0458-716-9621-B