Assigning Your Locomotive A New Id - Lionel ALCo S-2 Owner's Manual

TrainMaster Command operations

Assigning your locomotive a new ID#

Assign a new ID# to your
Example
Command-equipped locomotive
Set the Command reverse unit switch
to PRG
Command Base plugged in
Place the locomotive on track
PowerMasters set to CMD or traditional
power supplies ON FULL (no more than
19 volts)
Turn track power on (PowerMasters):
Press TR
Enter the PowerMaster's
ID#
Press BOOST
Program the locomotive with a new ID#:
Press ENG
Press a number you choose
(the ID#)
Press SET
Set the Command reverse unit switch to
RUN
Your locomotive remembers its ID#
forever; change it any time with these
steps
A
s your fleet of Command-equipped
Lionel locomotives grows, you'll want
to give your locomotive a more
individualized number. Choose from any
between 1 and 99. To make things easy, use
a portion of your locomotive's cab number.
Set the locomotive's Command reverse
unit switch to PRG (see Figure 1 on
page 5). Plug in the Command Base and
place the locomotive on track, then power
up. Using your CAB-1 Remote Controller,
press ENG, the locomotive ID# that you
select and then press the SET button
located under your CAB-1 Remote
Controller's removable panel. Hear the
horn sound (or see the headlight flash if
the RailSounds sound system is off); that's
the Command reverse unit confirming the
new ID#. Set the Command reverse unit
switch to RUN. Your locomotive is ready for
operations with its all-new ID#.
We recommend that you choose an easy to
remember ID# for your engine. Some possi-
bilities are part of the engine road number,
your age, or any two digit number that is not
used by another engine. Write the number on
a small piece of tape and put this on the
bottom of the fuel tank to aid in
remembering.
14