Eaton 9155 User Manual page 23

10. Verify that each UPS battery circuit breaker is in the OFF position
(see Figure 9).
Battery
Connector
UPS Wiring
Access Cover
Conduit Landing
11. From each UPS, remove the UPS wiring access cover and retain
(see Figure 9).
12. Hardwire the UPS input terminations (TB1‐1 through TB1‐5) for each
UPS.
See Table 2 for specifications and Figure 10 for a detailed view of
the UPS terminal block.
Eaton 9155 Parallel UPS (8–15 kVA) User's Guide
Figure 9. UPS Rear View (2-High Shown)
S
164201592 Rev D www.eaton.com/powerquality
PARALLEL INSTALLATION
ON
OFF
Battery Circuit Breaker
17