Remote Transmitter Learn - Titan TS 141A Installation Manual

INSTALLATION MANUAL

Remote Transmitter Learn

Important! The remote starter will hold 4 transmitter codes. It is
recommended that when programming in transmitters, you fill up all
four transmitter codes, even if only using one or two transmitters.
This will clear all other transmitter coding from the unit and prevent
stray coding or possible interference from other remote transmitters.
STEP 1 - Within 3 seconds turn the ignition key to the "ON"
position three times leaving "ON" the third time.
STEP 2 - Press and hold the Program Button. The park
lights will turn "ON" and the horn (optional) will
honk once. Continue to hold the Program
Button, the park lights will turn "OFF" and the
horn (optional) will honk 5 times quickly.
NOTE: If the parking lights do not turn "ON", release the Program Button and
turn the ignition to the "OFF" position, wait 5sec and repeat steps 1 & 2.
STEP 3a (Default) - While holding the Program Button, press and
STEP 3b (2nd Car) - While holding the Program Button, press and
Status
2nd Car function allows the operation of two remote starter systems
(in two separate vehicles) with one remote transmitter.
Example: Press and hold the
and then within 3 seconds press whichever function you wish to perform.
NOTE: Some features not available with 2nd car mode.
release the button on each of the remote
transmitters to be programmed. If using two
transmitters, code in each transmitter twice.
hold the
Status
until the blue light on the remote comes on
solid and within 3 seconds push the
button until the blue light stays on
Status
TS141A REMOTE STARTER
button on the second car remote
button.