Wire Description - Titan TS 141A Installation Manual

INSTALLATION MANUAL

Wire Description

MAIN CONNECTOR (6pin)
Pin
1-PURPLE
2-ORANGE
3-RED
4-RED
5-PINK
6-PNK/WHT
AUXILIARY CONNECTOR (14pin)
Pin
1-BLUE
2-RED/WHT
3-GREEN/BLK
4-ORANGE
5-BROWN
6-BLK/WHT
7-VIOLET
8-WHITE
Function
Starter Output This wire will test 0V in OFF, ACCESSORY and in
the ON key positions. 12v during START ONLY.
Heater/Acc Output
key positions. 12-14V in the ACCESSORY and RUN key positions.
12volt Input(30amp) - Supplies 12votls for the IGNITION, PARK
LIGHT and SELECTABLE outputs.
12volt Input(30amp)
STARTER outputs.
-
Ignition Output
key positions.12V in the IGNITION, START and RUN positions
Selectable Output
2nd STARTER.
Function
-
Re-arm(-) 0.75 second pulse output when
remote start shutdown. Used for factory alarm re-arm.
Trunk Release(-)
3 seconds, output will stay active (max 5 seconds) or (-)park light.
-
Dis-arm(-) 0.75 second pulse when
remote starter activation. Used for factory alarm dis-arm.
Ground When Running(-)
/Starter Kill (-) Programmable Starter Kill.
-
Horn(-) Output to activate factory horn.
No Connection
No Connection
-
Park Light(+) 10amp positive output to activate park lights.
Programmable output
TS141A REMOTE STARTER
Description
-
This wire will test 0V in the OFF and START
-
Supplies 12 volts for ACCESSORY and
This wire will test 0V in the OFF and ACCESSORY
-
Output for 2nd IGNITION, 2nd ACCESSORY or
Description
-
Programmable output. Hold
-
Output active during remote start.
is pressed and after
or button for
and is pressed and before
Continued on next page...