Titan TS 141A Installation Manual page 17

TS141A REMOTE STARTER
Menu 3- Starter Settings
M3–1 Gas/Diesel Mode
1. Time Delay – Waits for approximately 15 seconds before cranking
2. (-) Glow Plug input – Waits max. 90 seconds to crank (2 sec. if no
signal detected)
M3–2 Run Time
1. 4 Minutes – Runs for approx. 4 minutes when activated
2. 45 Minutes – Runs for approx. 45 minutes when activated
3. 15 Minutes – Runs for approx. 15 minutes when activated
M3-3 Maximum Crank Time
1. 10 seconds – 10 seconds maximum that the starter will stay engaged
2. 3 seconds - 3 seconds maximum that the starter will stay engaged
3. 5 seconds - 5 seconds maximum that the starter will stay engaged
Your Install Is Complete!
NOTES:
1) If the vehicle does not start when the remote starter is activated, the
park lights will flash a diagnostic code. (See Diagnostic Chart below).
2) If the vehicle still does not start, check all connections and check for
factory Anti-Theft system.
Transmitter
x x
5 flashes on button 2
5 flashes on button 3
5 flashes on button 1
5 flashes on button 4
x
Vehicle lights
System is in valet mode
3 slow flashes
4 slow flashes Door Open
5 slow flashes Ignition ON
Brakeswitch engaged
5 flashes
6 flashes Hoodswitch (hood open)
Tach lock-out
7 flashes
INSTALLATION MANUAL
****Bold text indicates default settings****
Problem Solution
Cancel Valet Mode
Manual trans. models only
Turn off Ignition key and try again
Check brakeswitch connection
Check hoodswitch adjustment
Start vehicle with key, after 5 sec. try again