Transmitter Learning - Titan ts143 Owner's Manual

MANUAL TRANSMISSION READY MODE cont'd
DIAGNOSTICS
If the remote starter does not activate when the Start button is pressed, the park lights will flash a
diagnostic code to indicate what shutdown input prevented starting.
PARK LIGHT FLASHES
3 Slow Flashes
4 Slow Flashes
5 Slow Flashes
5 Flashes
6 Flashes
7 Flashes

TRANSMITTER LEARNING

Important! The remote starter will hold 4 transmitter codes. It is recommended that when
programming in transmitters, you fill up all four transmitter codes, even if only using one or two
transmitters. This will clear all other transmitter coding from the unit and prevent stray coding or
possible interference from other remote transmitters.
In you purchase new transmitters, they will have to be programmed to your unit before they will
function. Your local Titan dealer can do this for you, but in the event you do not have access to
a dealer, you can program them in yourself. All transmitters to be used on the vehicle must be
programmed in at the same time. If you try to add only one transmitter, when you add it, it will
erase all other transmitter in the system, so you must code in all transmitters. This is a security safety
feature in the event you lose a transmitter.
IGNITION ON
CODING IN TRANSMITTERS
1. Within 3 seconds, turn ignition key On and Off 3 times, leaving the key in the "ON" position
(On-Off-On-Off-On).
2. Press and hold the Program button on the antenna (center of windshield). The park lights will
turn "On" and the horn/siren (optional) will honk once. Continue to hold the Program button.
The park lights will turn "Off" and the horn/siren (optional) will honk 5 times quickly.
3. While holding the Program button, press and release the Lock button on each of the remote
transmitters to be programmed. If using two transmitters, code in each transmitter twice. Turn
off the key. One long horn honk will follow to show you have exited programming.
Titan Data Series TS143 Owner's Guide
PROBLEM
System is in Service Mode
Door Open
Ignition On
Brakeswitch Engaged
Hoodswitch (Hood Open)
Tach Lock-Out/Failed Start
SOLUTION
Cancel Service Mode
Manual Transmission Models
Only
Turn Off Ignition Key
and Try Again
Check Brakepedal or Consult
Dealer
Close Hood and/or Check
Hoodpin Switch or Consult
Dealer
Start Vehicle with Key, Wait
5 Seconds and Try Again or
Consult Dealer
Hold
11