Transmitter Learning - Titan TS 131A Owner's Manual

Important! The remote starter will hold 4 transmitter codes. It is
recommended that when programming in transmitters, you fill up all
four transmitter codes, even if only using one or two transmitters.
This will clear all other transmitter coding from the unit and prevent
stray coding or possible interference from other remote transmitters.
STEP 1 - Within 3 seconds turn the ignition key to the "ON"
position three times leaving "ON" the third time.
STEP 2 - Press and hold the Program Button. The park
lights will turn "ON" and the horn (optional) will
honk once. Continue to hold the Program
Button, the park lights will turn "OFF" and the
horn (optional) will honk 5 times quickly.
NOTE: If the parking lights do not turn "ON", release the Program Button and
turn the ignition to the "OFF" position, wait 5sec and repeat steps 1 & 2.
STEP 3a (Default) - While holding the Program Button, press and
STEP 3b (PadLoc/ - While holding the Program Button, press and
2nd Car)* release the
PadLoc is a safety feature that "LOCKS" the remote transmitter. To
"UNLOCK" the remote transmitter the
pressed simultaneously with the function chosen.
2nd Car function allows the operation of two remote starter systems
(in two separate vehicles) with one remote transmitter.
Example: Press and release
NOTE: Some features not available with PadLoc or 2nd car mode.

TRANSMITTER LEARNING

release the button on each of the remote
transmitters to be programmed. If using two
transmitters, code in each transmitter twice.
transmitters to be programmed.
or
and
button on each of the remote
button must be
simultaneously to remote start.