Titan TS 141A Installation Manual page 9

TS141A REMOTE STARTER
Wire Description
Pin Function
9-GRAY
10-GREEN
No Connection
11-BLACK
Ground(-)
12-PINK
13-VIOLET/
Tach(A/C)
WHITE
indicate vehicle is running. (Coil, Injector, cam/crank position sensors)
14-GRAY/
BLACK
signals. This wire also acts as an "instant start wire" when ignition is off.
LOCK/ UNLOCK CONNECTOR (3pin red)
Pin Function
1-GREEN
Lock (-)
2-EMPTY
3-BLUE
Unlock (-)
ANTENNA CONNECTOR (4pin Blue)
AUXILIARY CONNECTOR (3pin white)
Pin Function
1-WHITE/
Ground While Running(-)
VIOLET
2-BLACK
Ground(-)
3-RED
12volts(+)
Important!
Never install an AUTOMATIC TRANSMISSION module
into a MANUAL TRANSMISSION vehicle!
-
Hood Pin(-) Input to detect ground when hood is
MUST BE CONNECTED.
-
System chassis ground input.
-
Brake Light (+)
brake switch being applied.
-
A/C Tach signal input. Used to detect engine speed to
MUST BE CONNECTED
-
Diesel (-) Programmable Wait to Start Input. Detects negative
-
Programmable LOCK output. (Menu 1)
-
Programmable UNLOCK output. (Menu 1)
RF Antenna with Program Button and LEDs
is active.
-
250ma ground output.
-
250ma 12volt output.
Description
Positive brake light switch input. Used to detect the
Description
Description
-
250ma ground output while remote starter
INSTALLATION MANUAL
open.