Setting System Pass Code - Jet SPACE BALLZ Service Manual

PROGRAM SETUP INFORMATION
Step # 22
Setting the score state values - continued
Use the up or down arrow keys to change between the
different score states. Select the letter of the score state that
you would like to set. Push the "ENTER" button to select that
score sate.
Step # 23
Setting the bonus score state values
There are four different pre-set bonus score state values that
can be chosen by the operator. The values displayed on this
page correspond to the nine bonus score SEG displays along
the bottom of the playfield. The values on this screen are
displayed from left to right and the largest number will be in
the center channel. To change the bonus score state values,
push the "ENTER" button and then use the arrow keys to
select a new pay table. Push the "ENTER" button to confirm
your selection. Note: Any value two digit value can be used
for any channel. For information on how to program a
custom value, please contact JET.
Step # 24
Setting the system pass code
The system setup is protected by a numeric pass code. A pass
code is used so that operators can ensure settings cannot be
changed without proper permissions and proper access. The
setting can either be set to "ON" or "OFF". Push the "ENTER"
button to select the setting. If set to "ON" then select a four
digit numeric code. Push "ENTER" again to confirm your
code. Please remember the four digit code as you will not be
able to gain access to the setup pages without the proper
pass code. If you forget your pass code, contact JET.
DEFAULT PASSCODE
0000
Jennison Entertainment Technologies Space Ballz Service Manual Page 44