Jet SPACE BALLZ Service Manual page 14

Step # 2-C
How NOT to lift section # 3 out of the crate
DO NOT lift like shown in the photo to the right. Lifting the unit by
placing your hand on the bottom of the unit could damage the LED
Board installed in this area. There is no safe hand hold there. Instead
pull the unit out like shown in Step # 2-B and then place a hand on
the bottom of the metal cabinet.
DO NOT LIFT AS SHOWN IN PHOTO
Step # 2-D
Safely place section # 3 on the floor
Carefully place Section # 3 on the ground in a safe area away from
customers. Be very careful about the acrylic edge on the front of the
section. This section is fragile and does extend out further than the
bottom of the cabinet. If you cannot safely place this as seen in the
photo - lay the entire unit on its back. (Glass Facing Up)
2 PEOPLE REQUIRED - 150 POUNDS
Step # 3
Inspecting the right cabinet LED lights
1) Ensure that the 4-Pin Molex connector located on the upper left of
the cabinet (Section # 2) is properly connected and seated. There is
no way to access this connector after the top two sections are
installed.
THERE IS NO WAY TO ACCESS THIS CONNECTOR
AFTER THE TOP IS INSTALLED
Jennison Entertainment Technologies
INSTALLATION INSTRUCTIONS
CAUTION
WARNING
NOTICE
Space Ballz Service Manual
Check Box When This Step is Complete
Check Box When This Step is Complete
Check Box When This Step is Complete
Page 14