Jet SPACE BALLZ Service Manual page 26

Step # 7-E
Connecting Electrical Connectors
1) Plug each of the 8 Connectors into the corresponding connector
near the CPU (computer board). Each connector should be
numbered and will match the corresponding connector.
2) Once all 8 Connectors are inserted and properly seated. Be sure to
store all cables to the right of the main board away from sensitive
electronics and the computer's fan.
SOME CPU'S MARY VARY FROM PICTURE
Step # 7-F
Connecting Electrical Connectors
1) Locate the 10-Pin Molex connector in the right side of Section # 3.
Step # 7-G
Connecting Electrical Connectors
1) Pull the 10-Pin connector through the opening closest to the side
of the cabinet and plug it into the round LED board on the right side.
Jennison Entertainment Technologies
INSTALLATION INSTRUCTIONS
NOTICE
Space Ballz Service Manual
Check Box When This Step is Complete
Check Box When This Step is Complete
Check Box When This Step is Complete
Page 26