Clock Button; Light Button; Turbo Button; X-Fan Button - Kelvinator KSV35NRC User Manual

Features of the remote control
3
8
11
9
4
1
2
The lower 12
buttons are
revealed by
sliding the panel
downwards
1

CLOCK Button

The clock timer uses a 12 hour clock mode.
P ress this button to set the clock. When the clock signal
blinks, you can press or
want, when hold the or
the numbers increase or decrease by 10 per 0.5 seconds.
While the clock symbol is blinking, press the clock button
again or after 5 seconds with no operation, the clock
symbol will stop blinking and the time is set. Please note
the default time for the remote is 12:00 pm and it will
revert to this when the battery is changed. When the clock
symbol shows, the numbers are the actual time, when
the symbol is not shown, the numbers are for the timer.
4 Features of the remote contol Kelvinator Air Conditioning
12
5
10
6
7
button to set the time you
button more than 2 seconds,
2

LIGHT Button

Press this button while the air conditioner is operating to
switch the indicating lights of the indoor unit on or off.
The normal condition at start up is on.
3

TURBO Button

Pressing this button while the air conditioner is
operating will put the fan into the high speed turbo
mode. The indicator on the remote control will show.
Turbo mode will be cancelled if the mode or fan speed
is changed.
4

X-FAN Button

Pressing X -FAN button in COOL or DEHUMIDIFY mode, the
icon
is displayed and the indoor fan will continue
operation for 10 minutes in order to dry the indoor unit
even though you have turned off the unit.
5 ION-FILTER Button
Press this button to turn the cold plasma function on
and off.
6 TIMER-ON Button
Setting the Timer On or start time, press the Timer On
button and the "ON" symbol will flash in the display.
Press the or symbol to adjust the start time. Holding
the button down will scroll more rapidly through the start
time display. Pressing the Timer On button again will
cancel the timer on function.
Note:
After selecting the desired time wait 5 seconds and the
ON symbol will display permanently.
Default times for timer on and off are 8:00am and
5:00pm.
7 TIMER-OFF Button
Press this key to enter into TIMER OFF setup, in which
case the OFF icon will blink. The method of setting is the
same as for TIMER ON.
8 SWING V Button
Press this button to enable or disable the vertical
swing function. When disabling the vertical swing
function the guiding louver will stay at its last position.
9 SWING H Button
Press this button to enable or disable the horizontal
swing function. When disabling the horizontal swing
function the guiding louver will stay at its last position.