Table of Contents
Advertisement
4 EM 300 OPERATION MENUS
4.1
Introduction
160719 / /F
Purpose
The purpose of this chapter is to provide detailed information
about the commands and parameter settings in the EM 300
installation, test and runtime setup dialogue boxes. These are all
accessed from the Runtime Menu window.
The following topics are covered:
• Overview
• Runtime Menu
• Installation Menu
• Manual control
• Simulator
• Built-In Self Test
Note that the EM 300 system comprises several additional
graphical applications. These are explained in separate chapters in
this manual.
Access
The Runtime Menu dialogue box is started automatically when the
EM 300 is started, and it is by default placed in MBES
Workspace. If you close it by accident during a logging session,
you can restart it by clicking the icon in the Program group on the
EM 300 Launchpad. You may access the Runtime Menu at any
time if it is required to adjust certain parameters, but under normal
operating conditions these settings should be defined while not
logging and then remain unchanged during logging.
Operation menus
(page 108)
(page 110)
(page 124)
(page 140)
(page 143)
(page 145)
107
Advertisement
Table of Contents
