Pro-Form WHIRLWIND PRO User Manual page 10

5. Attach the Seat (20) to the Seat Post (6) with
four M8 Locknuts (66) and four M8 Split Washers
(72); start all the Locknuts, and then tighten
them. Note: The Locknuts and Split Washers
may be preattached to the underside of the
Seat.
6. Tip: To avoid pinching the Reed Switch
Wire (31), position it as shown in the inset
drawing.
Using a plastic bag to keep your fingers clean,
apply a small amount of the included grease to
the Handlebar Axle (33). Insert the Handlebar
Axle into the Frame (1) and center it.
5
20
6
72
66
6
Avoid pinching the Reed
Switch Wire (31)
33
Grease
10
31
31
1
1
33