Re-Installing The Modulator - PEUGEOT Satelis 500 Workshop Manual

Re-installing the modulator

Note: The modulator is already filled with
brake fluid when delivered. In order
not to lose any brake fluid when con-
necting the modulator, remove the
caps and connect the hydraulic
hoses one after the other.
- Place the modulator in its support.
Tightening torque: 2.2 m.daN.
- Position the hydraulic controls in the
indicated order:
• The hydraulic control coming from the LH
master cylinder. (1)
• The hydraulic control going to the rear brake
calliper. (2). Place it over the hydraulic
control. (1)
• The hydraulic control coming from the RH
master cylinder. (3)
• The hydraulic control going to the front
brake calliper. (4)
Tightening torque: 2.8 m.daN.
Note: Change the copper seals each time
they are removed.
- Connect the modulator.
- Bleed the hydraulic system according to the
required procedure.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
SERVICING THE ABS/MBS SYSTEM
3
1
2
4
57