Changing The Preset Programmes - Danfoss TP5000 + RF Installation And User Instructions Manual

Changing the preset programmes

For Days 1-5 (weekdays)
a) Press PROG until 1st pre-set time
and temperature (Event 1, Days
1,2,3,4,5) appears in display.
b) Use + or – buttons to adjust the
TIME (press and hold to change in
10 min increments)
c) Use L or M buttons to adjust the
TEMPERATURE.
d) Press PROG to move to next preset
time & temperature (Event 2)
e) Repeat steps b, c & d for
programming Events 3, 4, 5 & 6.
For Days 6-7 (weekends)
J Press PROG until 1st pre-set time
and temperature (Event 1 Days
6-7) appears in display.
J Repeat steps b, c and d above to
programme time and temperature
events for the weekend.
If you require just 2 Events per day (1 ON / 1 OFF)
J Follow steps a, b & c above to programme
Event 1 (ON)
J Press and hold M and - buttons together
for 3 seconds to skip events 2,3,4 & 5.
J Follow steps b & c to programme Event 6 (OFF)
To revert back to six events per day, reset the thermostat
(see page 8).
10
6 30
1
20
2 8 30
15
1 7 00
20