Changing The Preset Programmes; User Overrides - Danfoss TP4000 Installation Instructions Manual

Changing the preset programmes

GB
a) Press PROG until 1st pre-set time and
temperature appears in display.
b) Use + or – buttons to adjust the TIME (press
and hold to change in 10 min increments).
c) Use Λ or V buttons to adjust the
TEMPERATURE.
d) Press PROG to move to next preset time &
temperature (Event 2).
e) Repeat steps b, c & d for programming Events
3, 4, 5 & 6.
Note: Press and hold PROG at any time will make
th unit return to RUN mode.
Running your programme
Press PROG – the colon in the LCD display will
start to fl ash. The heating will now be controlled
with the programmed times and temperatures.

User Overrides

Sometimes you may need to change the way you
use your heating temporarily, i.e.due to unusually
cold weather. The TP4000 has several user overrides,
which can be selected without aff ecting the
thermostat programming.
Altering display to show either time
or actual room temperature
· Press + and – together to change between
settings.
8