Siemens COMBIMASTER Reference Manual page 39

Parameter
P965
Special Baud Rate 2
P966
PZD Send Interval
Time
P967
Last Received Control
Word
P968
Last Sent Status Word 0 – FFFF
P969
P971 • • • •
EEPROM storage
control
P986
Relay Output
38
Function Range
[Default]
0 – 255
(SW
Version :
3.00
onwards)
0 –
65535
[0]
(SW
Version :
3.00
onwards)
0 – FFFF
Hex
Hex
(SW
Version :
3.00
onwards)
0 – 1
[1]
0 – 3
[0]
(SW
Version :
3.00
onwards)
COMBIMASTER & MICROMASTER Integrated
Description / Notes
Specific to CAN (Access only possible with P099 = 2).
Specific to CAN (Access only possible with P099 = 2).
The rate in ms at which PZD is sent is set.
0 =
Values sent only after a remote request
1...65534 = Values sent after a preset time (in ms)
or after a remote request.
= Values sent whenever the PZD changes
65535
or after a remote request.
Specific to PROFIBUS-DP/CAN. See PROFIBUS / CAN
Handbooks for further details. (Access only possible
with P099 = 1 or 2).
This is the control word which was most recently received
and is currently active within the drive.
Specific to PROFIBUS-DP/CAN. See PROFIBUS / CAN
Handbooks for further details. (Access only possible
with P099 = 1 or 2).
This is the status word which currently represents the
operating state of the drive and which is returned on
demand to the requestor.
Specific to CAN (Access only possible with P099 = 2).
0 = Changes to parameter settings (including
are lost when power is removed.
1 = Changes to parameter settings are retained during
periods when power is removed.
IMPORTANT
Take care not to exceed the EEPROM write cycle limit of
50,000/parameter (approx.) when using the serial link to
update parameters, otherwise data loss or corruption may
occur. Read cycles are unlimited.
Relay 1 = Fault Relay (RL1)
Relay 2 = Brake Relay
0 = Relay 1 & 2 - open.
1 = Relay 1 – closed
2 = Relay 2 – closed
3 = Relay 1 & 2 - closed
Siemens plc. 1999
©
REFERENCE MANUAL
P971
| G85139-H1731-U300-D2