Siemens COMBIMASTER Reference Manual page 5

WARNING
Take note of the general and regional installation and safety regulations regarding work
on high voltage installations (e.g. VDE). Adhere to relevant regulations regarding correct
use of tools and protective gear.
Use the lifting eyes provided if a motor is to be lifted. Do not lift machine sets by
suspending the individual machines! Always check the capacity of the hoist before lifting
any equipment.
Do not paint over the black case finish of the inverter as this will affect the units thermal
performance.
CAUTION
Do not allow children or the general public to access or approach this equipment.
Do not install the inverter where ambient conditions exceed the specified protection
rating. IP ratings: COMBIMASTER – IP55; MICROMASTER Integrated – IP65.
Keep operating instructions within easy reach and give them to all users.
Use this equipment only for the purpose specified by the manufacturer. Do not carry out
any modifications, or fit any spare parts which are not sold or recommended by the
manufacturer; this could cause fires, electric shock or other injuries.
The units are certified for compliance with
the following standards:
EN 60204-1 Safety of machinery -
Electrical equipment of machines
EN 60146-1-1 Semiconductor converters -
General requirements and line commutated
converters
BS EN50081-2 1995 General Emission
Standard - Industrial Environment
BS EN50082-2 1995 General Immunity
Standard - Industrial Environment.
4
EUROPEAN LOW
VOLTAGE & EMC
DIRECTIVES
The COMBIMASTER
product complies with the
requirements of the Low
Voltage Directive
73/23/EEC and the EMC
Directive 89/336/EEC.
COMBIMASTER & MICROMASTER Integrated
REFERENCE MANUAL
The MICROMASTER Integrated product
complies with the requirements of the Low
Voltage Directive 73/23/EEC.
The units are certified for compliance with
the following standards:
EN 60204-1 Safety of machinery -
Electrical equipment of machines
EN 60146-1-1 Semiconductor converters -
General requirements and line commutated
converters.
EUROPEAN MACHINERY DIRECTIVE
The MICROMASTER Integrated /
COMBIMASTER products are suitable for
incorporation into machinery.
The MICROMASTER Integrated /
COMBIMASTER must not be put into
service until the machinery into which it is
incorporated has been certified to be in
compliance with the provisions of the
European Directive 89/392/EEC.
Only valid for machinery to
be operated in the European
Community.
Siemens plc. 1999
© | G85139-H1731-U300-D2