Siemens COMBIMASTER Reference Manual page 50

COMBIMASTER & MICROMASTER Integrated
REFERENCE MANUAL
Parameter set in
Drive data (parameter
RAM, EEPROM
sets) save, open,
or PC drive
upload, download
On/Off Control for Drive
Figure 14 Example Screen From SIMOVIS Where Access to the Whole Parameter List Has Been
Operation of SIMOVIS within an Automation System
SIMOVIS can access the drives on a
PROFIBUS DP system when run on a PC or
PG with Step 7 V3.2 or higher. In this case the
Buskon program is not used and SIMOVIS can
be called directly by selecting the required
drive from the Step7 HWConfig program once
the PROFIBUS network has been configured.
Siemens plc. 1999
© | G85139-H1731-U300-D2
Direct Access
Parameter screen view,
to drive process
full list or specific
data
parameter groups
Drives found on Bus
Selected
Access to the drive parameters is identical to
the standalone case. Details on how to
configure the automation system are to be
found in the relevant Step7 documentation.
The hardware requirement for SIMOVIS is
identical to that for Step 7.
49