Siemens COMBIMASTER Reference Manual page 38

COMBIMASTER & MICROMASTER Integrated
REFERENCE MANUAL
Parameter Function
P928 • • • •
Local or Remote
control of drive
P930
Most recent fault code
P931
Most recent warning
type
P944
Reset to factory default
settings
P947
P958
P960
Protocol Type
P962
P963
P964
Siemens plc. 1999
© | G85139-H1731-U300-D2
Range
[Default]
0 – 3 Specific to PROFIBUS-DP/CAN. See PROFIBUS / CAN
Handbooks for further details. (Access only possible
[0]
with P099 = 1 or 2).
Determines which interface has control of the drive. Note
that the drive status can always be monitored.
0 = Drive control and setpoint source is local.
1 = Drive control and setpoint source is via Comms
Module.
2 = Drive control is local and setpoint source is via
Comms Module.
3 Drive control is via Comms Module and setpoint
source is local.
The last recorded fault code (see Section 6.3) is stored in
0 – 9999
this parameter. It is cleared when the inverter is
[-]
reset(P944=1).
0 – 9999 The last recorded warning is stored in this parameter until
power is removed from the inverter:
[-]
002 = Current limit active
004 = Slip limit exceeded
005 = Inverter over temperature (internal PTC)
006 = Motor overtemperature(I²T)
007 = Undervoltage
010..=..P10+/P15V/SK200 +5V Power Supply Fault
018 = Auto restart after fault(P018) is pending. The
inverter may start at any time.
Set to '1' and then press P to reset all parameters except
0 – 1
P101 to the factory default settings.
[0]
Specific to PROFIBUS-DP. See PROFIBUS Handbook for
further details. (Access only possible with P099 = 1).
Specific to PROFIBUS-DP. See PROFIBUS Handbook for
further details. (Access only possible with P099 = 1).
Specific to PROFIBUS-DP/CAN. See PROFIBUS / CAN
0 – 3
Handbooks for further details. (Access only possible
[0]
with P099 = 1 or 2).
(SW
Version :
Selects the CANbus protocol.
3.00
onwards)
0 = CAN communication disabled.
1 = CANopen communication enabled.
2 =CAN
(future).
3 = DeviceNet communication enabled (future).
Specific to CAN. (Access only possible with P099 = 2).
(SW
Version :
3.00
onwards)
(SW Specific to CAN (Access only possible with P099 = 2).
Version :
3.00
onwards)
(SW Specific to CAN (Access only possible with P099 = 2).
Version :
3.00
onwards)
Description / Notes
masterdrive commmunication enabled
37