Switching The Input Signal; Using The Laser Pointer - Panasonic PT-F100E Operating Instructions Manual

Remote control operation

Switching the input signal

You can switch the input method manually by
pressing the COMPUTER, NETWORK
(PT-F100NTE only) and VIDEO buttons.
Press the required button several times or I
H to cycle through the input methods as
follows. The actual projected image will be
changed in a while.
The graphical guidance will be displayed on the upper
right of the projected image and you can confirm the
selected input method which is highlighted in yellow. See
"INPUT GUIDE" on page 36.
Pressing the COMPUTER button
COMPUTER1
NOTE:
• Only when the COMPUTER2 SELECT is set to INPUT,
you can switch between COMPUTER1 and
COMPUTER2.
NOTE:
• If you select an unplugged input method, the guidance will blink on and off several times.
• See "List of compatible signals" on page 46.
• See "Connections" on page 20.

Using the laser pointer

You can highlight items on the screen with
the red laser pointer while projecting the
image in presentations or visual
demonstrations as an eye-catching pointing
device.
Hold down the LASER button to goes on the
laser pointer and release to goes off.
NOTE:
• The laser pointer should never be projected directly into
the eyes of a person or animal.
• Do not aim the laser at reflective surfaces.
• Do not allow children to use laser pointer.
• Never look directly into the laser beam.
• The laser pointer is not effective with translucent
screens.
• Please read the cautions on the Remote control.
• This is a Class 2 laser product.
Deactivating the LASER button
You can deactivate the LASER button for an
accidental operation.
1. Open the battery compartment cover of the
Remote control.
2. Slide the switch tab.
3. Close the battery compartment cover of the
Remote control.
See "Battery compartment" on page 13.
E
NGLISH - 26
COMPUTER2
CAUTION: Use of controls of adjustments or performance
of procedures other than those specified herein may result in
hazardous radiation exposure.
Pressing the NETWORK button
The NETWORK button is only for PT-F100NTE.
See CD-ROM contents for more detailed information.
Pressing the VIDEO button
VIDEO
COMPONENT
Pressing the INPUT SELECT
button on the projector
COMPUTER1
NETWORK
COMPONENT
NETWORK is only for PT-F100NTE.
Top view
Laser pointer beam emitter
Cautions
S-VIDEO
COMPUTER2
S-VIDEO
VIDEO
Deactivating switch
On
Off