Remote Terminal - Panasonic PT-F100E Operating Instructions Manual

REMOTE terminal

You can remotely operate the projector from the outside the Remote control range by connecting to the REMOTE
terminal.
Pin assignments and signal names
LAMP switching
Pin No.
B - A
Operation
Switching input signals
Pin No.
C - A
Open
E - A
Open
F - A
Open
Input signal
COMPUTER1 COMPUTER2 COMPONENT
NOTE:
• When pin A and pin I are short-circuited, the buttons on the projector's control panel, POWER and INPUT SELECT
buttons on the Remote control cannot be used. In addition, the RS-232C commands and network functions that
correspond to these functions cannot be used either.
• While pin I is "Open", do not short-circuit pin A, B, C, E and F. The projector would reject all the signals from the
Remote control.
Pin No. Signal name
GND
A
POWER
B
C INPUT SEL3
D
E INPUT SEL1
INPUT SEL2
F
G
H
ENABLE
I
Short
On
Open Short
Short Open
Open Short
Technical Information
Ground
POWER ON
Select input signal 3
NC
Select input signal 1
Select input signal 2
Connect internally
Control by external contact
Settings
Settings
Short
Open
Open
VIDEO S-VIDEO
Contents
Open
Off
Short Open
Short Short
Open Short
NETWORK
E
NGLISH - 49