Projecting An Image; Selecting The Input Signal; Positioning The Image - Panasonic PT-F100E Operating Instructions Manual

Projecting an image

Selecting the input signal

1. Switch on the connected devices.
Press the play button of the required device.
2. Press the INPUT SELECT buttons to select the
required input method if needed. See "Switching
the input signal" on page 26.
The image will be projected on the screen.

Positioning the image

1. Open the Front panel cover.
2. Adjust the projected image with the Lens shift
lever. See "Lens shift and positioning" on page 18.
3. Adjust the angle of the projector.
Screw down the Front leg adjusters and adjust the
angle vertically.
See "Front leg adjusters and throwing angle" on
page 17.
E
NGLISH - 24
NOTE:
• SIGNAL SEARCH is ON as default and the signal from
the connected devices is detected automatically. See
"SIGNAL SEARCH" on page 37.
4. Adjust the focus and the projected image size.
Turn the Focus lever and Zoom lever to adjust the
image.
You can confirm the adjusted effect with the TEST
PATTERN in OPTION menu. See "TEST PATTERN"
on page 38.
NOTE:
• Do not touch the Air Exhaust port as this may cause
burns or injury.
• If keystone distortion occurs, see "KEYSTONE" on
page 34.
• If you adjust the focus, you may need to adjust the size
of the image by moving the Zoom lever again.
Focus lever
Zoom lever