PICTURE menu
Remote control
See "Navigating through the MENU" on page 29.
See "Main menu and Sub-menu" on page 30.
PICTURE MODE
Depending on the projection environment, you can use
these preset parameter settings to optimise image
projection. Press I H to cycle through the options.
NATURAL
STANDARD
DYNAMIC
BLACKBOARD
NOTE:
• It may take for a while until the selected mode is
stabilised.
CONTRAST
You can adjust the contrast of the projected image.
Adjust the BRIGHTNESS in advance if necessary.
Lower
BRIGHTNESS
You can adjust the brightness of the projected image.
Darker
E
NGLISH - 32
Control panel
Reproduces the original colour
of the image
Setting for a general image
Bright and sharp setting
Setting for when projecting on
a blackboard
See "BLACKBOARD" on
page 38.
Higher
Brighter
COLOUR
You can adjust the colour saturation of the projected
image. (Available with signals from VIDEO/S-VIDEO/
COMPONENT only)
Lighter
TINT
You can adjust the skin tone in the projected image.
(Available with signals from VIDEO/S-VIDEO/
COMPONENT only)
More
reddish
SHARPNESS
You can adjust the sharpness of the projected image.
Less
sharp
COLOUR TEMPERATURE
You can adjust the white balance of the projected image.
LOW
More bluish
STANDARD
Balanced white
HIGH
More reddish
DAYLIGHT VIEW
You can keep the projected image bright and vivid even
in well-lit rooms where the ambient light sources cannot
be controlled, such as when a door opens or when
window coverings fail to block out sunlight.
AUTO:
Automatic adjustment
ON:
Active
OFF:
Deactive
NOTE:
• Do not cover the ALS (Ambient Luminance Sensor) of
the projector. See "ALS (Ambient Luminance Sensor)"
on page 14.
• AUTO is not available when INSTALLATION setting in
OPTION menu is set to REAR/DESK or REAR/
CEILING.
Darker
More
greenish
More
sharp