Replacing The Headlight Bulb - Yamaha 2010 XVS1100Z Owner's Manual

5. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15131]
Specified fuses:
Main fuse:
30.0 A
Backup fuse:
XVS1100AZ 10.0 A
XVS1100Z 5.0 A
Ignition fuse:
10.0 A
Headlight fuse:
15.0 A
Carburetor heater fuse:
15.0 A
Signaling system fuse:
10.0 A
Parking lighting fuse:
XVS1100AZ 10.0 A
6. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
7. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
PERIODIC MAINTENANCE AND ADJUSTMENT
8. Place the ignitor unit panel in the
original position and install the
quick fasteners.
9. Install the rider seat.
7-30

Replacing the headlight bulb

This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
NOTICE
Take care not to damage the follow-
ing parts:
G Headlight bulb
Do not touch the glass part of
the headlight bulb to keep it free
from oil, otherwise the transpar-
ency of the glass, the luminosity
of the bulb, and the bulb life will
be adversely affected. Thor-
oughly clean off any dirt and fin-
gerprints on the headlight bulb
using a cloth moistened with al-
cohol or thinner.
G Headlight lens
Do not affix any type of tinted
film or stickers to the headlight
lens.
Do not use a headlight bulb of a
wattage higher than specified.
EAU23795
ECA10650
7